Update

Hey folks, hope all is well out there!

Things have continued to be a bit rocky with timing the last 2 weeks but I’m hopeful that things are normalizing a bit. I expect to have less interruptions this week, with things opening up to pretty much all clear starting next week.

I have continued iterating on the enclosure’s internal layout and have things locked in. It has been a pretty tedious process. This is due to the outer enclosure’s assembly. To make anything more than minor adjustments to the internal layout, you have to disassemble entire sections of the outer enclosure. This is kind of the nature of the beast when using extrusions, channel entry points get blocked by other extrusions as they are connected. I have developed some new internal mounts that don’t require access to channel entry points to connect them to the extrusion. Not quite ready for release yet, but in addition to simplifying the last bits of enclosure work, it will also simplify customizing fully assembled units.

The rest of this week will be wrapping up the enclosure and should be good to share in 3-5 days. I’m very eager to get back to demos and planning shipments, and I appreciate everyone’s continued support over the last several weeks.

That is all for now, cheers!