Hey folks! Hope all is well. I’ve been head down and scratching off tasks. The last few days I have been finishing any outstanding UI work. Just about wrapped with recipe related UI. Here is the pour designer:

This view is a bit busier than I typically like, but there’s gotta be a way to tell the water where to go. I feel like I distilled things down into the simplest possible interface that still does the job. Or at least pretty close to it.

There are a few design/layout/font issues here but they are mostly upstream from this component and will be handled in a couple fit and finish stories.

Other bits:

PCBs went to fab late, expect to get them early next week.
Think I will have an RC ready for the front end in another week or two.
Not sure if I will be doing demos next weekend, probably going to wait until the new PCBs arrive.

Ok, that’s all for now. Next update will be out next weekend. Cheers!

Update!