Hey folks, hope all is well!

Updates will be a bit light for another week or so while I continue to work on internal component layouts. Primary work is getting the grinder positioning correct without impacting the spout movement or adding complexity to the build steps. Things have shifted around quite a bit since we last visited this piece of the project.

I hope to have grinder demos ready for next weekend, but if not, I will at least be ready to show the setup in more detail.

While that is moving forward I’m also updating some external aspects of the enclosure:

You may notice that the panels now extend a bit further to completely cover the extrusions. Beyond a nicer fit and finish, I have also tweaked how some sections combine. The goal here is to lower the assembly complexity and step count where possible.

And I still have not figured out how to get a pic that shows the screen graphics and the enclosure at their best simultaneously…

Ok, that is all for now. Next update will be next weekend. Design repo will have some updates going out before then.

Cheers!